Typical Enabling Conditions
WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
The following conditions are common to ON malfunctions (a), (b), (c) and (d).
TYPICAL ENABLING CONDITIONS CHART
| The monitor runs whenever the following DTCs are not present | None |
| Transmission shift position | D |
| Time after shifting N to D | 4.5 seconds or more |
| ATF (Automatic Transmission Fluid) temperature | -10°C (14°F) or more |
| ATF temperature sensor (TFT sensor) circuit | No circuit malfunction |
| Electronic Throttle Control System (if applicable) | No circuit malfunction |
| Shift solenoid valve S1 circuit | No circuit malfunction |
| Shift solenoid valve S2 circuit | No circuit malfunction |
| Shift solenoid valve SLU circuit | No circuit malfunction |
| Shift solenoid valve SLT circuit | No circuit malfunction |
| Speed sensor (NT) circuit | No circuit malfunction |
| Speed sensor (SPD) circuit | No circuit malfunction |
ON malfunction (a):
TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (A)
| ECM gearshift command | 1st |
| Input (turbine) speed | 300 rpm or more |
| Output speed | 300 rpm or more |
ON malfunction (b):
TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (b)
| ECM gearshift command | 2nd |
| Input (turbine) speed | 300 rpm or more |
| Output speed | 300 rpm or more |
ON malfunction (c):
TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (c)
| ECM gearshift command | 3rd |
| Input (turbine) speed | 300 rpm or more |
| Output speed | 300 rpm or more |
ON malfunction (d):
TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (d)
| ECM gearshift command | 4th |
| Input (turbine) speed | 300 rpm or more |
| Output speed | 300 rpm or more |