LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Tire & Wheel) >> TIRE PRESSURE WARNING RECEIVER (w/Antenna) >> Removal

TIRE PRESSURE WARNING RECEIVER (w/Antenna): Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE REAR DOOR SCUFF PLATE RH (See appropriate step(s) under  REMOVAL  ) 
  3. REMOVE PACKAGE TRAY TRIM POCKET SUBASSEMBLY (w/o Rear No. 2 Seat) 
  4. REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat) 
  5. REMOVE REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat) 
  6. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat) 
  7. REMOVE NO. 2 SEAT HINGE COVER LH (w/Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  8. REMOVE NO. 2 SEAT HINGE COVER RH (w/Rear No. 2 Seat) 

    Use same procedure as step above.

  9. REMOVE NO. 2 SEAT LEG COVER LH (w/Rear No. 2 Seat) (See appropriate step(s) under REMOVAL  ) 
  10. REMOVE NO. 2 SEAT LEG COVER RH (w/Rear No. 2 Seat) 

    Use same procedure as step above.

  11. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  12. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/Rear No. 2 Seat) 

    Use same procedure as step above.

  13. REMOVE REAR FLOOR NO. 3 BOARD 
  14. REMOVE REAR FLOOR NO. 2 BOARD 
  15. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (See appropriate step(s) under  REMOVAL  )  .
  16. REMOVE REAR FLOOR FINISH PLATE (See appropriate step(s) under  REMOVAL  ) 
  17. REMOVE REAR DECK TRIM COVER RH (w/Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  18. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  19. REMOVE TETHER ANCHOR BRACKET SUBASSEMBLY (w/o Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/o Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  21. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (w/Rear No. 2 Seat) (See appropriate step(s) under  REMOVAL  ) 
  22. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (See appropriate step(s) under  REMOVAL  ) 
  23. REMOVE TIRE PRESSURE WARNING ANTENNA AND RECEIVER 
    1. Disconnect the connector.
    2. Remove the bolt and receiver.
      Fig 1: Removing Bolt And Receiver
      G04489317Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals