On-Vehicle Inspection

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE STARTER RELAY (Marking: STARTER)
1. Remove the engine room relay block cover.
2. Remove the starter relay from the engine room relay block.

INSPECT STARTER RELAY

Measure the resistance of the starter relay.

Standard resistance

STARTER RELAY

Tester Connection	Specified Condition
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

Fig 1: Inspecting Starter Relay

If the result is not as specified, replace the relay.

INSTALL STARTER RELAY