LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Brake Pad, Brake Caliper & Brake Rotor >> Reassembly

Rear Brake Pad, Brake Caliper & Brake Rotor: Reassembly

  1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG 
  2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP 
  3. INSTALL PISTON SEAL 
    1. Apply lithium soap base glycol grease to a new piston seal.
    2. Install the piston seal onto the disc brake cylinder.
      NOTE: Securely install the piston seal into the groove of the disc brake cylinder.
  4. INSTALL REAR DISC BRAKE PISTON 
    1. Apply lithium soap base glycol grease to the piston.
    2. Install the piston into the disc brake cylinder.
      NOTE: Do not forcibly install the piston into the disc brake cylinder.
  5. INSTALL CYLINDER BOOT 
    1. Apply lithium soap base glycol grease to a new cylinder boot.
    2. Install the cylinder boot onto the disc brake cylinder.
      NOTE: Securely install the cylinder boot into the grooves of the disc brake cylinder and piston.
scientia non olet · About LEMON Manuals