REAR SEAT ASSEMBLY (for RH Side): Installation

INSTALL REAR SEATBACK ASSEMBLY
1. Engage the hook and temporarily install the rear seatback with the 2 bolts.
2. Tighten the 2 bolts.
  Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
3. Pull up the rear seatback.
  
  Fig 1: Identifying Rear Seatback Bolt Tightening Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the rear seat inner belt into the rear seatback holder.
5. Install the anchor plate of the rear center seat outer belt with the bolt.
  Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not place the anchor plate over the convex area of the rear seat inner belt.
  
  Fig 2: Identifying Rear Center Seat Outer Belt With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY
1. Pull the rear seatback lock release button and tilt the rear seatback forward.
2. Engage the 10 clips and install the rear seatback board carpet.
3. Pull up the rear seatback.
  
  Fig 3: Identifying Rear Seatback Board Carpet Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SEAT CUSHION ASSEMBLY
1. Insert the locating pin into the body hole.
2. Temporarily install the rear seat cushion with the 2 bolts.
3. Tighten the 2 bolts.
  Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
  
  Fig 4: Identifying Rear Seat Cushion Bolt Tightening Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002