Unlock Warning Switch: Inspection
- INSPECT UNLOCK WARNING SWITCH
- Check the resistance.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value (s) in the table below.
Standard Resistance
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Condition Specified Condition 1-2 Pin released 10 kΩ or higher 1-2 Pin pushed in Below 1 Ω Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the unlock warning switch.
- Using an ohmmeter, measure the resistance and check the results in accordance with the value (s) in the table below.
- Check the resistance.