REAR BRAKE SHOE, WHEEL CYLINDER & BRAKE DRUM (for TMMC Made): Disassembly

HINT:

Overhaul the RH side by the same procedures as LH side.

1. REMOVE REAR WHEEL 
2. DRAIN BRAKE FLUID 
   NOTE: Wash the brake fluid off immediately if it comes into contact with any painted surface.
3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY 
   1. Put matchmarks on the rear brake drum sub-assembly and the axle hub.
   2. Release the parking brake lever, and remove the brake drum.

      HINT:

      If the brake drum cannot be removed easily, do the following steps.

      Fig 1: Identifying Matchmarks On Rear Brake Drum Sub-Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.
   4. Using an another screwdriver, reduce the brake shoe adjuster by turning the adjusting wheel.
   Fig 2: Adjusting Brake Shoe Adjuster

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH 
   1. Using SST, remove the upper side tension spring with spacer.
   2. Remove the rear brake automatic adjust lever LH from the rear brake shoe.
   Fig 3: Removing Upper Side Tension Spring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. REMOVE FRONT BRAKE SHOE 
   1. Using a needle-nose pliers, remove the anchor side return spring.
      Fig 4: Removing Anchor Side Return Spring

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using SST, remove the cup, shoe hold-down spring and pin.

      SST 09718-00011 

      Fig 5: Removing Cup, Shoe Hold-Down Spring And Pin

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Disconnect the upper side return spring from the front shoe, and remove the front brake shoe.
6. REMOVE PARKING BRAKE SHOE STRUT SET LH 
7. REMOVE REAR BRAKE SHOE 
   1. Using SST, remove the cup, shoe hold-down spring and pin.

      SST 09718-00011 

      Fig 6: Removing Cup, Shoe Hold-Down Spring And Pin

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using a needle-nose pliers, disconnect the parking brake cable No. 3 and remove the rear brake shoe.
   3. Remove the upper side return spring from the rear brake shoe.
   Fig 7: Disconnecting Parking Brake Cable No. 3

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY 
   1. Using a screwdriver, remove the C-washer and parking brake shoe lever.
   Fig 8: Removing C-Washer And Parking Brake Shoe Lever

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY 
   1. Using SST, disconnect the brake tube, use a container to catch brake fluid.

      SST 09023-00101 

   2. Remove the 2 bolts and wheel cylinder.
      Fig 9: Locating Brake Tube

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. REMOVE REAR WHEEL CYLINDER CUP KIT 
    1. Remove the 2 cylinder dust boots from the wheel cylinder.
    2. Remove the 2 pistons and compression spring.
    3. Remove the 2 wheel cylinder cups from each piston.
    4. Remove the bleeder plug cap and bleeder plug from the wheel cylinder.