Transmission Control Cable Assembly: Removal

PRECAUTION
HINT:

See PRECAUTION
SEPARATE BATTERY NEGATIVE TERMINAL
REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE UPPER CONSOLE PANEL (See REMOVAL )
REMOVE CONSOLE BOX CARPET
HINT:

(See REMOVAL )
REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (See REMOVAL )
REMOVE CENTER AIRBAG SENSOR ASSEMBLY
HINT:

(See REMOVAL )
SEPARATE OXYGEN SENSOR CONNECTOR
1. Remove the foot rest.
2. Pull up the floor carpet.
3. Disconnect the oxygen sensor connector.
REMOVE FLOOR PANEL BRACE FRONT
1. Remove the 2 nuts and floor panel brace.
REMOVE FRONT EXHAUST PIPE ASSEMBLY
REMOVE NO.1 FRONT FLOOR HEAT INSULATOR
1. Remove the 3 nuts and heat insulator.
REMOVE AIR CLEANER ASSEMBLY WITH HOSE
REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
1. Remove the nut and disconnect control cable from control shaft lever.
2. Remove the clip and disconnect the control cable from the bracket.
  
  Fig 1: Identifying Clip And Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the control cable from control cable support.
  
  Fig 2: Identifying Control Cable Support
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 nuts and separate the control cable from the body.
  
  Fig 3: Identifying Control Cable Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the cable end from the floor shift assembly.
  
  Fig 4: Identifying Control Cable End
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Using a screwdriver, disconnect the control cable from the shift lever plate.
  HINT:
  
  Tape up the screwdriver tip before use.
  
  Fig 5: Identifying Shift Lever Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the 2 bolts.
8. Pull out the control cable assembly from the body.
9. Remove the retainer from the shift cable.