Transmission Control Cable: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the control cable assembly to the grommet.
2. Install the retainer to the grommet.
  NOTE: Fit 4 projections of the grommet into 4 holes of the retainer.
  
  Fig 1: Identifying Control Cable Assembly To Grommet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the control cable assembly with the 2 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Locating Control Cable Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the clamp with the 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 3: Locating Nuts And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the control cable assembly to the control cable bracket, and install 2 new clips.
6. Connect the control cable assembly to the transaxle, and install the 2 washers and 2 clips.
Fig 4: Locating Transmission Control Cable Assembly Clip And Washers
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT
1. Connect the end of the select cable and clip to the shift lever assembly.
  
  Fig 5: Installing Clip And Separate End Of Select Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the select cable to the retainer of the shift lever assembly, and turn the lock.
  NOTE: The projecting part of the lock should face upward when the select cable is installed.
3. Install the cable outer spring to the lock.
NOTE: Make sure that after installation the cable outer spring is moved to the place shown in the illustration.

Fig 6: Identifying Cable Outer Spring To Lock
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT
1. Connect the end of the shift cable and clip to the shift lever assembly.
  
  Fig 7: Installing Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the shift cable to the retainer of the shift lever assembly, and turn the lock.
  NOTE: The projecting part of the lock should face upward when the shift cable is installed.
3. Install the cable outer spring to the lock.
NOTE: Make sure that after installation the cable outer spring is moved to the place shown in the illustration.

Fig 8: Identifying Cable Outer Spring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT FLOOR HEAT INSULATOR NO. 1
1. Install the heat insulator No. 1 with the 3 nuts.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
INSTALL EXHAUST PIPE ASSEMBLY
HINT:

(See INSTALLATION )
CONNECT AIRBAG SENSOR ASSEMBLY CENTER
1. Install the airbag sensor assembly center with the 3 bolts.
  Torque: 18 N*m (180 kgf*cm, 13 ft.*lbf)
INSPECT SRS WARNING LIGHT
HINT:

(See DTC CHECK / CLEAR )