LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla CE, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Trans - C59) >> Floor Shift Lever Assembly >> Removal

Floor Shift Lever Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 
  2. REMOVE CONSOLE PANEL UPPER  (See REMOVAL )
  3. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY 
  4. REMOVE CONSOLE BOX SUB-ASSEMBLY REAR  (See REMOVAL )
  5. SEPARATE FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT 
    1. Remove the clip and separate the end of the shift cable from the shift lever assembly.
      Fig 1: Removing Clip
      G05194216Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, release the cable outer spring.
    3. Turn the lock, and separate the shift cable from the shift lever retainer.
    Fig 2: Releasing Cable Outer Spring
    G05194217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. SEPARATE FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT 
    1. Remove the clip and separate the end of the select cable from the shift lever assembly.
      Fig 3: Removing Clip And Separate End Of Select Cable
      G05194218Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, release the cable outer spring.
    3. Turn the lock, and separate the select cable from the shift lever retainer.
    Fig 4: Releasing Cable Outer Spring
    G05194219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FLOOR SHIFT LEVER ASSEMBLY 
    1. Remove the 4 bolts and shift lever assembly.
    Fig 5: Removing Shift Lever Assembly Bolts
    G05194220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals