Clutch Release Cylinder: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL RELEASE CYLINDER BLEEDER PLUG
Torque: 8.4 N*m (85 kgf*cm, 74 in.*lbf)
INSTALL CLUTCH RELEASE CYLINDER KIT
1. Install the bleeder plug cap to the bleeder plug.
2. Install a new spring to the cylinder body.
3. Coat parts with lithium soap base glycol grease, as shown in the illustration.
  
  Fig 1: Coating Parts With Lithium Soap Base Glycol Grease
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the piston to the cylinder body.
  NOTE: Be careful not to damage the inside of the cylinder body.
5. Install the push rod to the cylinder body.
6. Install the boot to the cylinder body.