Clutch Release Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
1. Install the clutch release cylinder and tube bracket with the 2 bolts.
  Torque: 12 N*m (120 kgf*cm, 9 ft.*lbf)
2. Install the flexible hose tube with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
Fig 1: Installing Clutch Release Cylinder And Tube Bracket With Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
1. Using SST, connect the flexible hose tube.
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  SST 09023-00101
  
  Fig 2: Connecting Flexible Hose Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
BLEED CLUTCH PIPE LINE
1. Fill the brake reservoir tank with brake fluid and bleed clutch system.
  Torque: 8.4 N*m (85 kgf*cm, 74 in.*lbf)
INSPECT FOR CLUTCH FLUID LEAK