Clutch Pedal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE INSTRUMENT PANEL SUB-ASSEMBLY LOWER
HINT:

(See REMOVAL )
REMOVE CLUTCH PEDAL SPRING
REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
1. Remove the clip and hole pin.
Fig 1: Removing Clip And Hole Pin
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
1. with Cruise control:
  Disconnect the clutch switch assembly connector.
2. Disconnect the clutch start switch assembly connector.
3. Remove the 2 nuts, bolt and clutch pedal support assembly.
Fig 2: Removing Clutch Pedal Support Assembly Nuts And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH PEDAL SUB-ASSEMBLY
1. Remove the bolt and nut.
2. Remove the clutch pedal sub-assembly from the clutch pedal support.
  
  Fig 3: Removing Clutch Pedal Sub-Assembly Bolt And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH PEDAL PAD
REMOVE CLUTCH PEDAL BUSH
1. Remove the 2 bushes from the clutch pedal.
Fig 4: Removing Clutch Pedal Bushes
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 CLUTCH PEDAL CUSHION
1. Using needle-nose pliers, remove the No. 1 cushion from the clutch pedal.
Fig 5: Removing No. 1 Clutch Pedal Cushion
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
1. Using an 8 mm hexagon wrench and a hammer, remove the clevis bush from the clutch pedal sub-assembly.
Fig 6: Removing Clevis Bush From Clutch Pedal Sub-Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002