Clutch Master Cylinder: Removal

WARNING: This page is about a different variant/trim than selected.

DRAIN CLUTCH FLUID
REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (See REMOVAL )
REMOVE BRAKE BOOSTER ASSEMBLY (See REMOVAL )
DISCONNECT CLUTCH RESERVOIR TUBE
1. Loosen the clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.
  HINT:
  
  Use a container to catch the fluid.
Fig 1: Disconnecting Clutch Reservoir Tube
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
1. Using SST, disconnect the flexible hose tube.
  HINT:
  
  Use a container to catch the fluid.
  
  SST 09023-00101
  
  Fig 2: Disconnecting Flexible Hose Tube Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH PEDAL SPRING
REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
1. Remove the clip and hole pin.
  
  Fig 3: Removing Nuts And Clutch Master Cylinder Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
1. Remove the 2 nuts and clutch master cylinder assembly.