LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla CE, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (1ZZ-FE) >> Oil Pump >> Installation

Oil Pump: Installation

  1. INSTALL OIL PUMP ASSEMBLY 
    1. Install a new gasket onto the cylinder block.
      2. Fig 1: Identifying Gasket
      G05193419Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Align the spline teeth of the oil pump drive rotor with the large teeth of the crankshaft, then slide on the oil pump.
    3. Install the oil pump with the 5 bolts.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      4. Fig 2: Aligning Spline Teeth Of Oil Pump Drive Rotor With Large Teeth Of Crankshaft
      G05193420Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CHAIN VIBRATION DAMPER NO.1 

    Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

  3. INSTALL CHAIN SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL CHAIN TENSIONER SLIPPER  (See INSTALLATION )
  5. INSTALL CRANKSHAFT POSITION SENSOR PLATE NO.1  (See INSTALLATION )
  6. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL  (See INSTALLATION )
  7. INSTALL TIMING CHAIN OR BELT COVER SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL CHAIN TENSIONER ASSEMBLY NO.1  (See INSTALLATION )
  9. INSTALL CRANKSHAFT PULLEY  (See INSTALLATION )
  10. INSTALL CRANKSHAFT POSITION SENSOR  (See INSTALLATION )
  11. INSTALL WATER PUMP ASSEMBLY  (See INSTALLATION )
  12. INSTALL ENGINE MOUNTING BRACKET RH  (See INSTALLATION )
  13. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY  (See INSTALLATION )
  14. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY  (See INSTALLATION )
  15. INSTALL IGNITION COIL ASSEMBLY  (See INSTALLATION )
  16. INSTALL ENGINE MOUNTING INSULATOR RH  (See INSTALLATION )
  17. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  18. INSTALL VANE PUMP ASSEMBLY  (See INSTALLATION )
  19. INSTALL FAN AND GENERATOR V BELT 
  20. ADD ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  21. ADD ENGINE OIL  (see REPLACEMENT )
  22. CONNECT BATTERY NEGATIVE TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  23. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  24. INSPECT FOR OIL LEAK 
  25. INSTALL CYLINDER HEAD COVER NO.2  (See INSTALLATION )
  26. INSTALL ENGINE UNDER COVER RH 
  27. INSTALL FRONT WHEEL RH 

    Torque: 100 N*m (1,050 kgf*cm, 76 ft.*lbf) 

scientia non olet · About LEMON Manuals