LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla CE, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (1ZZ-FE) >> Thermostat >> Installation

Engine Cooling System (1ZZ-FE): Thermostat: Installation

  1. INSTALL THERMOSTAT 
    1. Install a new gasket onto the thermostat.
    2. Install the thermostat with the jiggle valve upward.

      HINT:

      The jiggle valve may be set within 10° of either side of the prescribed position.

      3. Fig 1: Installing Thermostat With Jiggle Valve Upward
      G05193392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL WATER INLET 
    1. Install the water inlet with the 2 nuts.

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

      2. Fig 2: Locating Water Inlet Nuts
      G05193388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  4. ADD ENGINE COOLANT  (see COOLANT )
  5. INSPECT FOR COOLANT LEAK  (see ON-VEHICLE INSPECTION )
  6. INSTALL ENGINE UNDER COVER RH 
scientia non olet · About LEMON Manuals