Inspection Procedure

1. Disconnect the E60 ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFIED CONDITION
   
   

   Tester Connection	Specified Condition
   E60-3 (TC) - E10-13 (TC)	Below 1 Ω
   E10-4 (CG) - Body ground

Fig 1: Identifying DLC3 And E60 ECU Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  .