Ignition Coil: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL IGNITION COIL ASSEMBLY
1. Install the 6 ignition coils with the 6 bolts.
  Torque: 10 N*m (102 kgf*cm, 10 ft.*lbf)
2. Connect the 6 ignition coil connectors.
Fig 1: Locating Ignition Coil Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 SURGE TANK STAY
1. Install the No. 1 surge tank stay with the bolt.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  NOTE: Make sure that there is no oil on the bolt threads.
  
  Fig 2: Locating No. 1 Surge Tank Stay Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the bolt and clamp.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 3: Locating Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
ADD ENGINE COOLANT (See ON-VEHICLE INSPECTION )
CHECK FOR ENGINE COOLANT LEAKS (See ON-VEHICLE INSPECTION )
INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY (See INSTALLATION )
INSTALL WINDSHIELD WIPER LINK ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )