LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - U660E (Except Hybrid)) >> Shift Lever >> Inspection

Shift Lever: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT TRANSMISSION CONTROL SWITCH 
    1. Measure the resistance between each terminal of the shift lock control unit assembly when the shift lever is moved to each position.

      Standard resistance 

      RESISTANCE SPECIFIED CONDITION

      Shift Position Tester Connection Specified Condition
      S, "+" and "-" 3-7 Below 1 Ω
      Except S, "+" and "-" 3-7 10 kΩ or higher
      Press continuously "+" (Upshift) 2-5 Below 1 Ω
      S 2-5 10 kΩ or higher
      Press continuously "-" (Downshift) 1-5 Below 1 Ω
      S 1-5 10 kΩ or higher

      If the resistance value is not as specified, replace the shift lock control ECU.

      Fig 1: Identifying Shift Lock Control Unit Connector Terminals
      G04976769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals