Section 10 (Starting System (2GR-FE)): Starter: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL STARTER ASSEMBLY
1. Install the starter assembly with the 2 bolts.
  Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf)
2. Connect the wire harness to terminal 30 and install the nut. Then, attach the terminal cap.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
3. Connect the terminal 50 connector to the starter assembly.
  
  Fig 1: Connecting Terminal 50 Connector To Starter Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER INLET ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )