LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Starting System (2GR-FE)) >> IGNITION SWITCH (w/o Smart Key System) >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Check the resistance.
      Fig 1: Inspecting Ignition Or Starter Switch Assembly
      G04975549Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Condition Tester Connection Specified Condition
      LOCK Between all terminals 10 kΩ or higher
      ACC 2-4 Below 1 Ω
      ON 1 -2-4 Below 1 Ω
      5-6
      START 1-3-4 Below 1 Ω
      5-6-7

      If the result is not as specified, replace the ignition or starter switch.

scientia non olet · About LEMON Manuals