LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Starting System (2GR-FE)) >> ENGINE SWITCH (w/ Smart Key System) >> Inspection

ENGINE SWITCH (w/ Smart Key System): Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ENGINE SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Inspecting Engine Switch
      G04975595Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      7 (SS1) -5 (GND) Pushed Below 1 Ω
      2 (SS2) - 5 (GND) Pushed Below 1 Ω
      7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
      2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.
      Fig 2: Identifying Indicator Light Connector
      G04975708Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Standard resistance 

    MEASUREMENT SPECIFIED CONDITION CHART

    Measurement Condition Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or S (GND)    		 Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)    		 Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)    		 Illuminates

    If the result is not as specified, replace the engine switch.

scientia non olet · About LEMON Manuals