Engine Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
HINT:

See REMOVAL .
REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
1. Using SST, hold the crankshaft.
  SST 09213-70011 (09213-70020), 09330-00021
  
  Fig 1: Holding Crankshaft Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 8 bolts, front spacer, drive plate and rear spacer.
  
  Fig 2: Removing Bolts, Front Spacer, Drive Plate And Rear Spacer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ENGINE REAR OIL SEAL
1. Using a knife, cut off the oil seal lip.
2. Using a screwdriver, pry out the oil seal.
  NOTE: Be careful not to damage the crankshaft. Tape the screwdriver tip before use.
  
  Fig 3: Prying Out Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002