Engine Rear Oil Seal: Installation

1. Apply MP grease to a new oil seal lip.
2. Using SST and a hammer, tap in the oil seal.

   SST 09223-15030, 09950-70010 (09951-07150) 

   Oil seal tap in depth: 

   -0.5 to 0.5 mm (-0.020 to 0.020 in.) 

   Fig 1: Tapping In Oil Seal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft.

   SST 09213-70011 (09213-70020), 09330-00021 

   Fig 2: Holding Crankshaft Using SST

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply adhesive to 2 or 3 threads of the mounting bolt end.

   Adhesive: 

   Part No. 08833-00070, THREE BOND 1324 or equivalent 

   Fig 3: Applying Adhesive To 2 Or 3 Threads Of Mounting Bolt End

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the front spacer, drive plate and rear spacer on the crankshaft.
   2. Install and tighten the 8 mounting bolts uniformly in several steps.

      Torque: 83 N*m (850 kgf*cm, 61 ft.*lbf) 

      Fig 4: Tightening Mounting Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

See INSTALLATION .