Rear Brake Pad, Brake Caliper & Brake Rotor: Installation

INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY
1. Install the disc brake cylinder assembly with the 2 bolts.
  Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
  
  NOTE: Install the rear disc brake bushing dust boot onto the groove of the rear disc brake cylinder.
  
  Fig 1: Installing Disc Brake Cylinder Assembly With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT REAR BRAKE FLEXIBLE HOSE
1. Connect the flexible hose with the union bolt and a new gasket.
  Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf)
  
  Fig 2: Locating Union Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RESERVOIR WITH BRAKE FLUID (See ON-VEHICLE INSPECTION )
BLEED MASTER CYLINDER (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See BLEEDING )
BLEED BRAKE ACTUATOR ASSEMBLY (w/ VSC) (See BLEEDING )
INSPECT FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK FOR BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)