Rear Door Belt Moulding: Removal

REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG (See DISASSEMBLY )
REMOVE DOOR ASSIST GRIP COVER (See DISASSEMBLY )
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (See DISASSEMBLY )
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP (See DISASSEMBLY )
REMOVE REAR DOOR BELT MOULDING ASSEMBLY
1. Fully open the rear door glass.
2. Put protective tape around the rear door belt moulding assembly.
  
  Fig 1: Applying Protective Tape Around Rear Door Belt Moulding Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a moulding remover, disengage the clip and 6 claws, and remove the rear door belt moulding assembly.
  HINT:
  
  Tape the remover tip before use.
  
  NOTE: Be careful when removing the moulding as there are claws attached to the front end of the moulding.
  
  Fig 2: Identifying Rear Door Belt Moulding Assembly Clip And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002