Front Door Belt Moulding: Removal

REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See DISASSEMBLY )
REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG (See DISASSEMBLY )
REMOVE ASSIST GRIP COVER (See DISASSEMBLY )
REMOVE COURTESY LIGHT ASSEMBLY (See DISASSEMBLY )
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See DISASSEMBLY )
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP (See DISASSEMBLY )
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (See REMOVAL )
REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
1. Fully open the front door glass.
2. Put protective tape around the front door belt moulding assembly.
  
  Fig 1: Applying Protective Tape Around Front Door Belt Moulding Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a moulding remover, disengage the 2 clips and 5 claws, and remove the front door belt moulding assembly.
  HINT:
  
  Tape the remover tip before use.
  
  NOTE: Be careful when removing the moulding as there are claws attached to the front and rear ends of the moulding.
  
  Fig 2: Identifying Front Door Belt Moulding Assembly Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002