LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior (Except Hybrid) >> Front Bumper >> Removal

Front Bumper: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE) 
    1. Remove the 7 clips and cool air intake duct seal.
      Fig 1: Identifying Cool Air Intake Duct Seal Clips
      G04981862Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light) 
    1. Put protective tape around the front bumper assembly.
      Fig 2: Applying Protective Tape Around Front Bumper Assembly
      G04981863Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      HINT:

      Use the same procedures for the RH side and LH side.

      Fig 3: Removing Pin Hold Clip
      G04981864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
      Fig 4: Identifying Radiator Grille Protectors Screws And Clips
      G04981865Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

      HINT:

      Use the same procedures for the RH side and LH side.

    5. Remove the front bumper assembly.
      Fig 5: Removing Front Bumper Assembly
      G04981866Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light) 
    1. Put protective tape around the front bumper assembly.
      Fig 6: Applying Protective Tape Around Front Bumper Assembly
      G04981867Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      HINT:

      Use the same procedures for the RH side and LH side.

      Fig 7: Removing Pin Hold Clip
      G04981864Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
      Fig 8: Identifying Radiator Grille Protectors Screws And Clips
      G04981869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

      HINT:

      Use the same procedures for the RH side and LH side.

    5. Disconnect each connector, and then remove the front bumper assembly.
      Fig 9: Removing Front Bumper Assembly
      G04981870Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002