Vanity Light: Inspection

INSPECT VANITY LIGHT ASSEMBLY

Measure the voltage according to the value(s) in the table below.

Standard voltage:

LH Side

Fig 1: Identifying Vanity Light Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

VOLTAGE SPECIFICATION LH

Tester Connection	Condition	Specified Condition
Q7-1 - Q7-2	Visor raise	Below 1 V
	Visor lower and mirror cover open	11 to 14 V
	Visor lower and mirror cover close	Below 1 V

RH Side

VOLTAGE SPECIFICATION RH

Tester Connection	Condition	Specified Condition
Q8-1 - Q8-2	Visor raise	Below 1 V
	Visor lower and mirror cover open	11 to 14 V
	Visor lower and mirror cover close	Below 1 V

If the result is not as specified, there is a malfunction on the wire harness side.

If the result is as specified, but the vanity light light does not come on, replace the bulb.