LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting (Except Hybrid) >> Turn Signal Flasher Assembly >> On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT TURN SIGNAL FLASHER ASSEMBLY 
    1. Disconnect the E14 turn signal flasher assembly connector.
    2. Measure the voltage and resistance according the value(s) in the table below.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      E14-1 (IG) - Body ground Ignition switch off Below 1 V
      E14-1 (IG) - Body ground Ignition switch on (IG) 10 to 14 V
      E14-4 (B) - Body ground Always 10 to 14 V
      Fig 1: Identifying E14 Turn Signal Flasher Connector Terminals
      G04980233Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      E14-5 (EL) - Body ground Turn signal switch OFF 10 kΩ or higher
      E14-5 (EL) - Body ground Turn signal switch in LH position Below 1 Ω
      E14-6 (ER) - Body ground Turn signal switch OFF 10 kΩ or higher
      E14-6 (ER) - Body ground Turn signal switch in RH position Below 1 Ω
      E14-7 (E) - Body ground Always Below 1 Ω
      E14-8 (HAZ) - Body ground Hazard warning switch OFF 10 kΩ or higher
      E14-8 (HAZ) - Body ground Hazard warning switch ON Below 1 Ω

      If the result is not as specified, there may be a malfunction on the wire harness side.

    3. Reconnect the turn signal flasher assembly connector.
    4. Measure the voltage according to the valve(s) in the table below.

      Standard voltage 

      VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      E14-2 (LR) - Body ground Hazard warning switch OFF Below 1 V
      E14-2 (LR) - Body ground Hazard warning switch ON 10 to 14 V (60 to 120 times per minute)
      E14-2 (LR) - Body ground Turn signal switch OFF Below 1 V
      E14-2 (LR) - Body ground Ignition switch on (IG) and turn signal switch in RH position 10 to 14 V (60 to 120 times per minute)
      E14-3 (LL)- Body ground Hazard warning switch OFF Below 1 V
      E14-3 (LL) - Body ground Hazard warning switch ON 10 to 14 V (60 to 120 times per minute)
      E14-3 (LL) - Body ground Turn signal switch OFF Below 1 V
      E14-3 (LL) - Body ground Ignition switch on (IG) and turn signal switch in LH position 10 to 14 V (60 to 120 times per minute)
      E14-5 (EL) - Body ground Ignition switch on (IG) and turn signal switch OFF 10 to 14 V
      E14-5 (EL) - Body ground Ignition switch on (IG) and turn signal switch in LH position Below 1 V
      E14-6 (ER) - Body ground Ignition switch on (IG) and turn signal switch OFF 10 to 14 V
      E14-6 (ER) - Body ground Ignition switch on (IG) and turn signal switch in RH position Below 1 V
      E14-8 (HAZ) - Body ground Hazard warning switch OFF 10 to 14 V
      E14-8 (HAZ) - Body ground Hazard warning switch ON Below 1 V

      If the result is not as specified, replace the turn signal flasher assembly.

scientia non olet · About LEMON Manuals