LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting (Except Hybrid) >> Stop Light Switch >> Inspection

Stop Light Switch: Inspection

  1. INSPECT STOP LIGHT SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Switch Position Specified Condition
      1 - 2 Switch pin free Below 1 Ω
      Switch pin pushed in 10 kΩ or higher
      3 - 4 Switch pin free 10 kΩ or higher
      Switch pin pushed in Below 1 Ω

      If the result is not as specified, replace the stop light switch assembly.

      Fig 1: Identifying Stop Light Switch Connector Terminals
      G04980212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals