Rear Room Light Assembly: Inspection

INSPECT NO. 1 ROOM LIGHT ASSEMBLY (without Sliding Roof)

Measure the resistance according to the value(s) in the table below.

Standard resistance

RESISTANCE REFERENCE

Tester Connection	Condition	Specified Condition
Q9-3 - Body ground	Always	Below 1 Ω

If the result is not as specified, repair or replace harness or connector.

Fig 1: Identifying No. 1 Room Light Connector Terminals (Wire Harness Side)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage according to the value(s) in the table below.

Standard voltage

VOLTAGE SPECIFICATION

Tester Connection	Condition	Specified Condition
Q9-1 - Body ground	Always	11 to 14 V

If the result is not as specified, repair or replace the harness or connector.

INSPECT SPOT LIGHT ASSEMBLY (with Sliding Roof)

Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH Side

RESISTANCE REFERENCE LH

Tester Connection	Condition	Specified Condition
Q11-4 - Body ground	Always	Below 1 Ω

RH Side

RESISTANCE REFERENCE RH

Tester Connection	Condition	Specified Condition
Q10-4 - Body ground	Always	Below 1 Ω

If the result is not as specified, repair or replace harness or connector.

Fig 2: Identifying Spot Light Connector Terminals (Wire Harness Side)

Measure the voltage according to the value(s) in the table below.

Standard voltage:

LH Side

VOLTAGE SPECIFICATION LH

Tester Connection	Condition	Specified Condition
Q11-2 - Body ground	Always	11 to 14 V

RH Side

VOLTAGE SPECIFICATION RH

Tester Connection	Condition	Specified Condition
Q10-2 - Body ground	Always	11 to 14 V

If the result is not as specified, repair or replace the harness or connector.