Rear Combination Light Assembly: Reassembly

INSTALL REAR LIGHT GASKET
1. Remove the release paper from a new rear light gasket.
  NOTE:
  - Be sure to remove all traces of the old gasket from the body.
  - Do not reuse the removed gasket. Be sure to install a new rear light gasket to prevent water ingress.
2. Align the rear light gasket with the 3 stud bolts and install the gasket as shown in the illustration.
  
  Fig 1: Locating Rear Light Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TAIL LIGHT BULB
1. Install the tail light bulb to the rear light socket and wire.
2. Turn the tail light bulb and rear light socket and wire in the direction indicated by the arrow and install them as a unit.
  
  Fig 2: Installing Back Up Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK UP LIGHT BULB
1. Install the back up light bulb to the rear light socket and wire.
2. Turn the back up light bulb and rear light socket and wire in the direction indicated by the arrow and install them as a unit.
  
  Fig 3: Turning Back Up Light Bulb And Rear Light Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR BUMPER RETAINER UPPER
1. Engage the claw and install the rear bumper retainer upper.
  
  Fig 4: Identifying Rear Bumper Retainer Upper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR TURN SIGNAL LIGHT BULB
1. Install the rear turn signal light bulb to the rear turn signal light socket.
2. Turn the rear turn signal light bulb and rear turn signal light socket in the direction indicated by the arrow and install them as a unit.
INSTALL TAIL AND STOP LIGHT BULB
1. Install the tail and stop light bulb to the tail and stop light socket.
2. Turn the tail and stop light bulb and tail and stop light socket in the direction indicated by the arrow and install them as a unit.
  
  Fig 5: Turning Tail, Stop Light Bulb And Stop Light Socket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT GASKET
1. Remove the release paper from a new rear combination light gasket.
  NOTE:
  - Be sure to remove all traces of the old gasket from the body.
    
    Fig 6: Installing Rear Combination Light Gasket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.
2. Align the rear combination light gasket with the 3 stud bolts and install the gasket as shown in the illustration.
  
  Fig 7: Locating Rear Combination Light Gasket With Stud Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002