LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting (Except Hybrid) >> Hazard Warning Switch >> Inspection

Hazard Warning Switch: Inspection

  1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      5 - 4 OFF 10 kΩ or higher
      5 - 4 ON Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch assembly.

    2. Apply battery voltage to the hazard warning signal switch assembly connector.

      OK 

      VOLTAGE SPECIFICATION

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 7
      Battery negative (-) → Terminal 8      		 Illumination comes on

      If the result is not as specified, replace the hazard warning signal switch assembly.

      Fig 1: Identifying Hazard Warning Signal Switch Connector Terminals
      G04980209Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals