Park / Neutral Position Switch: Inspection

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Shift Position	Specified Condition
1 (RB) - 3 (PL) 4 (B) - 9 (L)	P position	Below 1 Ω
1 (RB) - 3 (PL) 4 (B) - 9 (L)	Except P position	10 kΩ or higher
2 (RL) - 1 (RB)	R position	Below 1 Ω
2 (RL) - 1 (RB)	Except R position	10 kΩ or higher
1 (RB) - 8 (NL) 4 (B) - 9 (L)	N position	Below 1 Ω
1 (RB) - 8 (NL) 4 (B) - 9 (L)	Except N position	10 kΩ or higher
1 (RB) - 7 (DL)	D position, S position, "+" and "-"	Below 1 Ω
1 (RB) - 7 (DL)	Except D position, S position, "+" and "-"	10 kΩ or higher

Fig 1: Identifying Park/Neutral Position Switch Connector Terminal

If the result is not as specified, replace the park/ neutral position switch.