Typical Enabling Conditions
TYPICAL ENABLING CONDITIONS
| Monitor will run whenever these DTCs are not present | P0100 - P0103(MAF meter) P0110 - P0113(IAT sensor) P0115 - P0118 (ECT sensor) P0120 - P0223, P2135 (TP sensor) P0125 (Insufficient ECT for closed loop) P0327 - P0333 (knock sensor) P0335 (CKP sensor) P0500 (VSS) |
| Battery voltage | 8 V or more |
| Throttle position learning | Completed |
| VVT system | Not operate by scan tool |
| Engine RPM | 400 to 5,700 rpm |
| All of following conditions 1 and 2 are met | - |
| 1.ECT | -10°C(14°F) or more |
| 2. Either of following conditions (a) or (b) is met | - |
| (a) Engine start ECT | Higher than-7°C(19°F) |
| (b)ECT | Higher than 20°C(68°F) |
| Fuel cut | OFF |
Monitor period of emission-related misfire:
TYPICAL ENABLING CONDITIONS CHART
| First 1,000 revolutions after engine start, or Check Mode | Crankshaft 1,000 revolutions |
| Except above | Crankshaft 1,000 revolutions x 4 |
Monitor period of emission-related misfire:
TYPICAL ENABLING CONDITIONS CHART
| All of following conditions 1, 2 and 3 are met | Crankshaft 200 revolutions x 3 |
| Except above | Crankshaft 200 revolutions |
| 1. Driving cycles | 1st |
| 2. Check Mode | OFF |
| 3. RPM | Less than 2,800 revolutions |