REAR NO. 2 SUSPENSION ARM (for 4WD): Removal

REMOVE REAR WHEEL
REMOVE REAR SUSPENSION NO. 2 ARM
1. Put matchmarks on the adjust cams and rear suspension member sub-assembly.
  
  Fig 1: Identifying Matchmarks On Adjust Cams And Rear Suspension Member Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the nut, camber adjust cam and toe adjust cam, and disconnect the rear suspension arm No.2 (inner side).
  NOTE: When removing the nut, keep the bolt from rotating.
3. Remove the bolt, nut and the rear suspension arm No.2 (outer side) from the rear axle carrier.
  
  Fig 2: Locating Rear Suspension Arm No.2 (Outer Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When removing the bolt, keep the nut from rotating.