REAR NO. 2 SUSPENSION ARM (for 4WD): Installation

1. Install the rear suspension arm No.2 (inner side) to the rear suspension member sub-assembly with the camber adjust cam and toe adjust cam, and temporarily tighten the nut.
   Fig 1: Locating Rear Suspension Arm No.2 (Inner Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   Ensure that the paint mark faces to the rear side of the vehicle.

2. Connect the rear suspension arm No.2 (outer side) to the rear axle carrier with the bolt and nut.
   Fig 2: Locating Rear Suspension Arm No.2 (Outer Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE: When temporarily tightening the bolt, keep the nut from rotating.

1. Put matchmarks on the adjust cams and rear suspension member sub-assembly.
   Fig 3: Locating Matchmarks On Adjust Cams And Rear Suspension Member Sub-Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the nut.

   Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf) 

3. Fully tighten the nut.

   Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf) 

   Fig 4: Locating Rear Suspension Arm No.2 (Outer Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

(See ADJUSTMENT  )