REAR NO. 2 SUSPENSION ARM (for 2WD): Installation

TEMPORARILY TIGHTEN REAR SUSPENSION NO. 2 ARM
1. Install the rear suspension arm No.2 (inner side) with the bolt, and temporarily tighten the bolt.
  
  Fig 1: Locating Rear Suspension Arm No.2 (Inner Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Ensure that the paint mark faces to the rear side of the vehicle.
2. Connect the rear suspension arm No.2 (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
  
  Fig 2: Locating Rear Suspension Arm No.2 (Outer Side) To Rear Axle Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When temporarily tightening the bolt, keep the nut from rotating.
STABILIZE SUSPENSION (See INSTALLATION )
FULLY TIGHTEN REAR SUSPENSION NO.2 ARM
1. Fully tighten the bolt.
  Torque: 120 N*m (1,220 kgf*cm, 89 ft.*lbf)
  
  Fig 3: Locating Rear Suspension Arm No.2 (Inner Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt.
  Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)
  
  Fig 4: Locating Rear Suspension Arm No.2 (Outer Side) To Rear Axle Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(See ADJUSTMENT )