REAR NO. 1 SUSPENSION ARM (for 4WD): Installation

TEMPORARILY TIGHTEN REAR SUSPENSION NO. 1 ARM
1. Install the rear suspension arm No. 1 (inner side) with the bolt, and temporarily tighten the bolt.
  
  Fig 1: Identifying Paint Mark Faces To Rear Side Of Vehicle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Ensure that the paint mark faces to the rear side of the vehicle.
2. Set the rear suspension arm No. 1 in the position shown in the illustration, and fully tighten the bolt.
  Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf)
  
  NOTE: When temporarily tightening the bolt, keep the nut from rotating.
3. Install the rear suspension arm No. 1 (outer side) to the rear axle carrier, and temporarily tighten the bolt.
  
  Fig 2: Locating Rear Suspension Arm No. 1 (Outer Side) To Rear Axle Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When temporarily tightening the bolt, keep the nut from rotating.
TEMPORARILY TIGHTEN REAR STRUT ROD (See REMOVAL )
STABILIZE SUSPENSION (See INSTALLATION )
FULLY TIGHTEN REAR SUSPENSION NO. 1 ARM
1. Fully tighten the bolt.
Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)

Fig 3: Locating Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FULLY TIGHTEN REAR STRUT ROD (See INSTALLATION )
CONNECT PARKING BRAKE NO.3 CABLE ASSEMBLY (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(See ADJUSTMENT )