LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (Hybrid) >> Spiral Cable >> Removal

Spiral Cable: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE STEERING WHEEL NO.3 COVER LOWER (See  REMOVAL   ) 
  5. REMOVE STEERING WHEEL NO.2 COVER LOWER (See  REMOVAL   ) 
  6. REMOVE STEERING PAD (See  REMOVAL   ) 
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE STEERING COLUMN COVER LOWER  (See REMOVAL )
  9. REMOVE STEERING COLUMN COVER UPPER  (See REMOVAL )
  10. REMOVE SPIRAL CABLE 
    1. Disconnect the connectors from the spiral cable.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Disengage the 3 claws and remove the spiral cable.
  11. REMOVE STEERING ANGLE SENSOR  (See INSPECTION )
scientia non olet · About LEMON Manuals