Engine Rear Oil Seal: Installation

1. Apply MP grease to a new oil seal lip.
   NOTE: Keep the lip free from foreign objects.
2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

   SST 09223-15030, 09950-70010 (09951-07100) 

   NOTE:

   • Do not tap the oil seal at an angle.
   • Wipe off extra grease on the crankshaft.
     Fig 1: Installing Engine Rear Oil Seal

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft.

   SST 09213-54015 (91651-60855), 09330-00021 

2. Clean the bolts and bolt holes.
3. Apply adhesive to 2 or 3 threads of the bolts.

   Adhesive: 

   Part No.08833-00070, THREE BOND 1324 or equivalent 

4. Install the flywheel on the crankshaft.
   Fig 2: Holding Crankshaft

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using several steps, install and tighten the 8 bolts uniformly in the sequence shown in the illustration.

   Torque: 83 N*m (846 kgf*cm, 61 ft.*lbf) 

   NOTE: Do not start the engine within 1 hour after installing.
   Fig 3: Locating Bolts Uniformly In Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft.

   SST 09213-54015 (91651-60855), 09330-00021 

   Fig 4: Holding Crankshaft

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 6 bolts and transmission input damper.
   Fig 5: Locating Transmission Input Damper And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf) 

   HINT:

   Take care not to insert the transmission input damper in the wrong direction.

(See INSTALLATION )