LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft ( Hybrid) >> REAR DRIVE SHAFT (for 4WD) >> Removal

REAR DRIVE SHAFT (for 4WD): Removal

  1. REMOVE REAR WHEEL 
  2. REMOVE REAR AXLE SHAFT NUT  (See REMOVAL )
  3. SEPARATE REAR SPEED SENSOR  (See REMOVAL )
  4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY  (See REMOVAL )
  5. REMOVE REAR DISC  (See REASSEMBLY )
  6. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.3  (See REMOVAL )
  7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY  (See REMOVAL )
  8. REMOVE REAR STRUT ROD ASSEMBLY  (See REMOVAL )
  9. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.1  (See INSTALLATION )
  10. SEPARATE REAR SUSPENSION ARM ASSEMBLY NO.2  (See INSTALLATION )
  11. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY  (See INSTALLATION )
  12. REMOVE REAR DRIVE SHAFT ASSEMBLY 
    1. Put matchmarks on the rear drive shaft assembly and differential side gear shaft.
    2. Remove the 4 nuts, washers and rear drive shaft assembly.
      Fig 1: Locating Rear Drive Shaft Assembly
      G05202383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals