REAR DRIVE SHAFT (for 4WD): Installation

INSTALL REAR DRIVE SHAFT ASSEMBLY
1. Align the matchmarks.
2. Install the rear drive shaft assembly with the 4 nuts and washers.
  
  Fig 1: Installing Rear Drive Shaft Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf)
INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (See INSTALLATION )
TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 (See INSTALLATION )
TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 (See INSTALLATION )
TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY (See INSTALLATION )
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (See INSTALLATION )
INSTALL REAR DISC (See REASSEMBLY )
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (See INSTALLATION )
INSTALL REAR SPEED SENSOR (See INSTALLATION )
INSTALL REAR AXLE SHAFT NUT
1. Using a socket wrench (30mm), install a new rear axle shaft nut.
  
  Fig 2: Installing Rear Axle Shaft Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 294 N*m (3,000 kgf*cm, 217 ft.*lbf)
2. Using a chisel and hammer, stake the rear axle shaft nut.
STABILIZE SUSPENSION (See INSTALLATION )
FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 (See INSTALLATION )
FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 (See INSTALLATION )
FULLY TIGHTEN REAR STRUT ROD ASSEMBLY (See INSTALLATION )
INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3 (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
ADJUST REAR WHEEL ALIGNMENT
(See REAR WHEEL ALIGNMENT )
CHECK SPEED SENSOR SIGNAL
(See TEST MODE PROCEDURE )