LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical (Hybrid) >> Rear Brake Pad, Brake Caliper & Brake Rotor >> Removal

Rear Brake Pad, Brake Caliper & Brake Rotor: Removal

  1. REMOVE REAR WHEEL 
  2. DRAIN BRAKE FLUID 
  3. DISCONNECT REAR FLEXIBLE HOSE 
    1. Remove the union bolt and the gasket from the rear disc brake cylinder assembly, then disconnect the flexible hose.
  4. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN NO.2 
    1. Remove the rear disc brake cylinder slide pin No.2.
  5. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN NO.1 
    1. Remove the rear disc brake cylinder slide pin No.1.
      Fig 1: Locating Rear Disc Brake Cylinder Slide Pin
      G05202935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY 
    Fig 2: Identifying Rear Disc Brake Cylinder Assembly
    G05241815Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the rear disc brake cylinder assembly.
scientia non olet · About LEMON Manuals