Front Brake Flexible Hose: Installation

INSTALL FRONT FLEXIBLE HOSE
1. Connect the front brake flexible hose with the union bolt and a new gasket.
  Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
2. Connect the front flexible hose and the speed sensor to the shock absorber with the bolt.
  Torque: 19 N*m (192 kgf*cm, 14 ft.*lbf)
  
  NOTE: When installing the front flexible hose and the speed sensor, the bracket must face toward the exterior of the vehicle.
  
  Fig 1: Locating Front Brake Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the brake tube to the front brake flexible hose with SST while holding the flexible hose with a wrench.
  SST 09023-00101
  
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Do not bend or damage the brake tube.
  - Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting points.
4. Install the front brake flexible hose with a new clip.
  
  Fig 2: Locating Front Brake Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - When installing the front brake flexible hose, face the identification mark toward the exterior of the vehicle and minimize twisting of the hose.
  - Install the clip as far as it will go.
ADD RESERVOIR WITH BRAKE FLUID (See BRAKE PEDAL )
DISABLE BRAKE CONTROL (See BLEEDING )
BLEED FRONT BRAKE SYSTEM (See BLEEDING )
CANCEL BRAKE CONTROL DISABLE (See BLEEDING )
CLEAR DTC
(See DTC CHECK / CLEAR )
PERFORM ACCUMULATOR ZERO DOWN (See BLEEDING )
CHECK BRAKE FLUID LEVEL (See BRAKE PEDAL )
INSPECT FOR BRAKE FLUID LEAK
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CLEAR DTC
(See DTC CHECK / CLEAR )