REAR NO. 1 SEAT ASSEMBLY (w/o Rear No. 2 Seat for RH Side): Removal

1. Move the rear No.1 seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
Fig 1: Identifying Claws Of Rear Seat Track Bracket Cover Inner
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a screwdriver, disengage the 2 claws.

   HINT:

   Tape the screwdriver tip before use.

3. Pull the rear seat track bracket cover inner toward the rear of the vehicle and remove them.

HINT:

Use the same procedures as above to remove the rear seat track bracket cover outer.

1. Using a clip remover, remove the 5 clips.
2. Remove the bolt and disconnect the floor anchor side of the fold seat stopper band assembly No.1.
3. Move the rear No.1 seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
4. Remove the 2 bolts on the front side.
5. Move the rear No.1 seat assembly RH fully forward by operating the rear seat track adjusting handle.
6. Remove the 3 bolts on the rear side.
7. Move the rear seat assembly LH to the center position and adjust the seatback to the vertical position.
8. Remove the rear No.1 seat assembly RH.