REAR NO. 1 SEAT ASSEMBLY (w/o Rear No. 2 Seat for LH Side): Removal

1. Move the rear No.1 seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
2. Using a screwdriver, disengage the 2 claws.

   HINT:

   Tape the screwdriver tip before use.

3. Pull the rear seat track bracket cover inner toward the rear of the vehicle and remove them.
   Fig 1: Identifying Rear Seat Track Bracket Cover Inner Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures as above to remove the rear seat track bracket cover outer.

1. Using a clip remover, remove the 3 clips.
2. Remove the bolt and disconnect the floor anchor side of the fold seat stopper band assembly No. 1.
3. Move the rear No. 1 seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
4. Remove the 2 bolts on the front side.
5. Move the rear No.1 seat assembly LH fully forward by operating the rear seat track adjusting handle.
6. Remove the 3 bolts on the rear side.
7. Move the rear No. 1 seat assembly LH to the center position and adjust the seatback to the vertical position.
8. Remove the rear No. 1 seat assembly LH.