REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 2 Seat for RH Side): Disassembly

1. Remove the 3 screws.
2. Disengage the 4 claws and remove the rear seat cushion molding RH as shown in the illustration.
   Fig 1: Locating Claws And Rear Seat Cushion Molding RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 screws.
2. Disengage the 5 claws and remove the rear seat cushion molding rear RH.
   Fig 2: Locating Claws Of Rear Seat Cushion Molding Rear RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the screw.
2. Disengage the 2 claws and remove the vertical adjuster bracket cover outer.

1. Disengage the 4 clips and remove the reclining hinge cover RH.
   Fig 3: Locating Clips And Reclining Hinge Cover RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a "Torx" socket wrench (T45), remove the 2 "Torx" bolts.
2. Release the 2 rubber bands on the backside of the rear seatback board carpet assembly.
3. Remove the 2 clamps.
4. Remove the 2 bolts and separate type rear seat cushion assembly.

1. Disengage the hooks and remove the hog rings and rear seat cushion frame sub-assembly.

1. Remove the hog rings and separate type rear seat cushion cover.

1. Remove the screw and remote control lever knob.

1. Using a screwdriver, disengage the 4 claws and remove the 2 covers.

   HINT:

   Tape the screwdriver tip before use.

2. Remove the 3 screws and rear seat cover bezel No.1.

1. Remove the screw and tonneau cover hook holder.

1. Using a molding remover, disengage the 4 claws and remove the rear seatback cover.
   Fig 4: Identifying Claws Of Rear Seatback Cover

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disengage the 7 clips and remove the rear seatback board carpet assembly.
   Fig 5: Identifying Clips Of Rear Seatback Board Carpet Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a screwdriver, disengage the 2 claws and remove the rear seatback lock striker cover.

   HINT:

   Tape the screwdriver tip before use.

1. Remove the 2 screws.
   Fig 6: Identifying Screws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the rear seat reclining control No.2 cable and remove the rear seat lock control lever sub-assembly.

1. Disengage the 2 claws and remove the rear seat headrest support (LH side).
Fig 7: Locating Hog Rings
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures described for the LH side.

1. Disengage the hooks and remove the hog rings and separate type rear seatback cover with pad.

1. Remove the hog rings and separate type rear seatback cover.

1. Remove the reclining adjuster inside cover RH.

1. Remove the screw and rear seatback cover No.2 RH.

1. Remove the screw and seat track upper rail cover RH.

1. Remove the screw.
2. Remove the rear seat reclining cover inner RH as shown in the illustration.
   Fig 8: Locating Rear Seat Reclining Cover Inner RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the screw and rear seat cover No.2.

1. Remove the clamp.
2. Disconnect the 5 cables and remove the 2 rear seat reclining control No.2 cables.

1. Using a "Torx" socket wrench (T45), remove the 4 "Torx" bolts and rear seatback frame sub-assembly.

1. Remove the clamp.
2. Disengage the 2 seat track stop plate cables.
3. Remove the 2 nuts and seat track stop plate.

1. Remove the 3 nuts and rear back lock control lever sub-assembly.

1. Remove the 2 E-rings and 2 springs.
2. Remove the 4 nuts and reclining control link sub-assembly.

1. Using a "Torx" socket wrench (T45), remove the 5 "Torx" bolts and rear seatback frame sub-assembly lower.

1. Remove the 4 nuts and 2 fold seat cushion frames No.2.

1. Move the rear seat track assembly outer and rear seat track assembly inner fully forward by operating the rear seat track adjusting handle.
2. Using a hexagon wrench 1.5 mm (0.059 in.), push down the 2 handle stoppers as shown in the illustration and remove the rear seat track adjusting handle.
Fig 9: Identifying Rear Seat Track Adjusting Handle
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002