REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 2 Seat for LH Side): Installation

INSTALL REAR NO.1 SEAT ASSEMBLY LH
1. Place the rear No. 1 seat assembly LH in the vehicle and align the adjuster pin with the hole on the vehicle side.
2. Move the rear No.1 seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
  NOTE: Check that the seat is locked.
3. Temporarily install the front side of the rear No. 1 seat assembly LH with the 2 bolts.
4. Recline the separate type rear seatback forward by operating the rear seat lock control lever sub-assembly.
5. Move the rear No.1 seat assembly LH fully forward.
  NOTE: Check that the seat is locked.
6. Temporarily install the rear side of the rear No. 1 seat assembly LH with the 3 bolts.
7. Return the separate type rear seatback to the upright position.
8. Move the rear No.1 seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
  NOTE: Check that the seat is locked.
9. Fully tighten the 2 bolts on the front side of the rear No.1 seat assembly LH in the order of the inner side bolt and then the outer side bolt.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
10. Recline the separate type rear seatback forward by operating the rear seat lock control lever sub-assembly.
11. Move the rear No.1 seat assembly LH fully forward.
  NOTE: Check that the seat is locked.
12. Fully tighten the 3 bolts on the rear side of the rear No.1 seat assembly LH in the order of the inner rear side bolt, the inner front side bolt, and then the outer side bolt.
  Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
INSTALL SEAT TRACK COVER INNER LH
INSTALL REAR SEAT TRACK BRACKET COVER INNER LH
INSTALL REAR SEAT TRACK COVER LH
INSTALL REAR SEAT TRACK BRACKET COVER OUTER
INSTALL RECLINING HINGE COVER LH
INSPECT SLIDE ADJUSTER LOCK
1. Check that the left and right adjusters lock simultaneously when sliding the seat.
2. If the left and right adjusters do not lock simultaneously, adjust by loosening the bolts securing the seat.